User Tools
Sidebar
cisco:firepower-anyconnect
Cisco Firepower AnyConnect
If you are using the BRI1 interface for your inside (LAN) network you will need to disable NAT exemption in the AnyConnect configuration and manually create a NAT rule.
| Placement | Before Auto NAT Rules |
| Type | Static |
| Original Packet | |
| Source Interface | Any |
| Source Address | LAN |
| Source Port | Any |
| Destination Address | AnyConnect |
| Destination Port | Any |
| Translated Packet | |
| Destination Interface | WAN |
| Source Address | LAN |
| Source Port | Any |
| Destination Address | AnyConnect |
| Destination Port | Any |
cisco/firepower-anyconnect.txt · Last modified: by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
